H-3206.2          _______________________________________________

 

                                  HOUSE BILL 2442

                  _______________________________________________

 

State of Washington              52nd Legislature             1992 Regular Session

 

By Representative Van Luven

 

Read first time 01/16/92.  Referred to Committee on Transportation.Protecting pedestrians in crosswalks.


     AN ACT Relating to pedestrian crosswalks; and amending RCW 46.61.235, 46.61.055, and 46.61.060.

 

BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF WASHINGTON:

 

     Sec. 1.  RCW 46.61.235 and 1990 c 241 s 4 are each amended to read as follows:

     (1) ((When traffic-control signals are not in place or not in operation,)) The operator of an approaching vehicle shall stop and remain stopped to allow a pedestrian to cross the roadway within an unmarked or marked crosswalk when the pedestrian is upon or within one lane of the half of the roadway upon which the vehicle is traveling ((, or when the pedestrian is upon the opposite half of the roadway and moving toward the approaching vehicle)) or onto which it is turning. For purposes of this section "half of the roadway" means all traffic lanes carrying traffic in one direction of travel, and includes the entire width of a one-way roadway.

     (2) No pedestrian shall suddenly leave a curb or other place of safety and walk, run, or otherwise move into the path of a vehicle which is so close that it is impossible for the driver to stop.

     (3) Subsection (1) of this section does not apply under the conditions stated in RCW 46.61.240(2).

     (4) Whenever any vehicle is stopped at a marked crosswalk or at any unmarked crosswalk at an intersection to permit a pedestrian to cross the roadway, the driver of any other vehicle approaching from the rear shall not overtake and pass such stopped vehicle.

 

     Sec. 2.  RCW 46.61.055 and 1990 c 241 s 2 are each amended to read as follows:

     Whenever traffic is controlled by traffic control signals exhibiting different colored lights, or colored lighted arrows, successively one at a time or in combination, only the colors green, red and yellow shall be used, except for special pedestrian signals carrying a word or legend, and said lights shall indicate and apply to drivers of vehicles and pedestrians as follows:

     (1) Green indication

     (a) Vehicle operators facing a circular green signal may proceed straight through or turn right or left unless a sign at such place prohibits either such turn.  ((But)) Vehicle operators turning right or left shall stop to allow other vehicles ((or pedestrians)) lawfully within the intersection control area to complete their movements.  Vehicle operators turning right or left shall also stop for pedestrians who are lawfully within the intersection control area as required by RCW 46.61.235(1).

     (b) Vehicle operators facing a green arrow signal, shown alone or in combination with another indication, may enter the intersection control area only to make the movement indicated by such arrow, or such other movement as is permitted by other indications shown at the same time.  ((The)) Vehicle operators shall stop to allow other vehicles ((or pedestrians)) lawfully within the intersection control area to complete their movements.  Vehicle operators shall also stop for pedestrians who are lawfully within the intersection control area as required by RCW 46.61.235(1).

     (c) Unless otherwise directed by a pedestrian control signal, as provided in RCW 46.61.060 as now or hereafter amended, pedestrians facing any green signal, except when the sole green signal is a turn arrow, may proceed across the roadway within any marked or unmarked crosswalk.

     (2) Steady yellow indication

     (a) Vehicle operators facing a steady circular yellow or yellow arrow signal are thereby warned that the related green movement is being terminated or that a red indication will be exhibited immediately thereafter when vehicular traffic shall not enter the intersection.  Vehicle operators shall stop for pedestrians who are lawfully within the intersection control area as required by RCW 46.61.235(1).

     (b) Pedestrians facing a steady circular yellow or yellow arrow signal, unless otherwise directed by a pedestrian control signal as provided in RCW 46.61.060 shall not enter the roadway((, but if pedestrians have begun to cross before the display of either signal, vehicle operators shall stop to allow them to complete their movements)).

     (3) Steady red indication

     (a) Vehicle operators facing a steady circular red signal alone shall stop at a clearly marked stop line, but if none, before entering the crosswalk on the near side of the intersection or, if none, then before entering the intersection control area and shall remain standing until an indication to proceed is shown.  However, the vehicle operators facing a steady circular red signal may, after stopping proceed to make a right turn from a one-way or two-way street into a two-way street or into a one-way street carrying traffic in the direction of the right turn; or a left turn from a one-way or two-way street into a one-way street carrying traffic in the direction of the left turn; unless a sign posted by competent authority prohibits such movement((; but)).  Vehicle operators planning to make such turns shall remain stopped to allow other vehicles lawfully within or approaching the intersection control area((, or approaching pedestrians lawfully within an adjacent crosswalk,)) to complete their movements.  Vehicle operators planning to make such turns shall also remain stopped for pedestrians who are lawfully within the intersection control area as required by RCW 46.61.235(1).

     (b) Unless otherwise directed by a pedestrian control signal as provided in RCW 46.61.060 as now or hereafter amended, pedestrians facing a steady circular red signal alone shall not enter the roadway.

     (c) Vehicle operators facing a steady red arrow indication may not enter the intersection control area to make the movement indicated by such arrow, and unless entering the intersection control area to make such other movement as is permitted by other indications shown at the same time, shall stop at a clearly marked stop line, but if none, before entering a crosswalk on the near side of the intersection control area, or if none, then before entering the intersection control area and shall remain standing until an indication to make the movement indicated by such arrow is shown.  However, the vehicle operators facing a steady red arrow indication may, after stopping proceed to make a right turn from a one-way or two-way street into a two-way street or into a one-way street carrying traffic in the direction of the right turn; or a left turn from a one-way street or two-way street into a one-way street carrying traffic in the direction of the left turn; unless a sign posted by competent authority prohibits such movement((; but)).  Vehicle operators planning to make such turns shall remain stopped to allow other vehicles lawfully within or approaching the intersection control area((, or approaching pedestrians lawfully within an adjacent crosswalk,)) to complete their movements.  Vehicle operators planning to make such turns shall also remain stopped for pedestrians who are lawfully within the intersection control area as required by RCW 46.61.235(1).

     (d) Unless otherwise directed by a pedestrian signal, pedestrians facing a steady red arrow signal indication shall not enter the roadway.

     (4) If an official traffic control signal is erected and maintained at a place other than an intersection, the provisions of this section shall be applicable except as to those provisions which by their nature can have no application.  Any stop required shall be made at a sign or marking on the pavement indicating where the stop shall be made, but in the absence of any such sign or marking the stop shall be made at the signal.

 

     Sec. 3.  RCW 46.61.060 and 1990 c 241 s 3 are each amended to read as follows:

     Whenever pedestrian control signals exhibiting the words "Walk" or the walking person symbol or "Don't Walk" or the hand symbol are operating, the signals shall indicate as follows:

     (1) WALK or walking person symbol--Pedestrians facing such signal may cross the roadway in the direction of the signal.  ((Pedestrians that begin to cross a roadway while facing such signal shall be granted the right to complete their crossing by all vehicle operators.))  Vehicle operators shall stop for pedestrians who are lawfully moving within the intersection control area on such signal as required by RCW 46.61.235(1).

     (2) Steady or flashing DON'T WALK or hand symbol--Pedestrians facing such signal shall not enter the roadway((, but if pedestrians have begun to cross before the display of either signal, vehicle operators shall stop to allow them to complete their movements)).  Vehicle operators shall stop for pedestrians who have begun to cross the roadway before the display of either signal as required by RCW 46.61.235(1).

     (3) Pedestrian control signals having the "Wait" legend in use on August 6, 1965, shall be deemed authorized signals and shall indicate the same as the "Don't Walk" legend.  Whenever such pedestrian control signals are replaced the legend "Wait" shall be replaced by the legend "Don't Walk" or the hand symbol.