PDFWAC 296-301-04503

Enclosed hot air dryers.

(1) Lever control. When slashers are operated by control levers, these levers must be connected to a horizontal bar or treadle located not more than 69 inches above the floor to control the operation from any point.
(2) Push-button control. Slashers operated by push-button control must have one start button at each end of the machine and stop buttons must be located on both sides of the machines at intervals spaced not more than 6 feet on centers.
Note:
Inching buttons should be installed.
(3) Dryer enclosure. The dryer enclosure must be provided with an exhaust system which will effectively prevent wet air and steam from escaping into the workroom.
(4) Nip guards. All nip guards must comply with Table R-1.
TABLE R-1
GUARD OPENINGS
Openings in the guard or between the guard and working surface must not be greater than the following:
Distance of
opening
from nip point
 
Maximum
width of opening
0 to 1 1/2
 
 
1/4
1 1/2 to 2 1/2
 
 
3/8
2 1/2 to 3 1/2
 
 
1/2
3 1/2 to 5 1/2
 
 
5/8
5 1/2 to 6 1/2
 
 
3/4
6 1/2 to 7 1/2
 
 
7/8
7 1/2 to 8 1/2
 
1
1/4
The measurements in Table R-1 are all in inches.
(5) Expansion chambers. Slasher kettles and cookers must be provided with expansion chambers in the covers, or drains, to prevent surging over. Steam control valves must be so located that they can be operated without exposing the worker to moving parts, hot surfaces, or steam.
[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, and 49.17.060. WSR 17-18-075, § 296-301-04503, filed 9/5/17, effective 10/6/17; Order 74-19, § 296-301-04503, filed 5/6/74.]