WSR 09-11-085

PERMANENT RULES

GAMBLING COMMISSION


[ Order 646 -- Filed May 18, 2009, 11:41 a.m. , effective July 1, 2009 ]


Effective Date of Rule: July 1, 2009.

Purpose: During the rules simplification project, the manufacturer requirements below were removed because, at that time, it was felt they did not need to be spelled out in our rules. However, after further review, staff have determined these should be added back into our rules. (1) Staff may conduct an on-site review of a manufacturer's processes; and (2) manufacturers must comply with quality control restrictions for gambling equipment used in Washington state.

Citation of Existing Rules Affected by this Order: Amending WAC 230-03-185.

Statutory Authority for Adoption: RCW 9.46.070.

Adopted under notice filed as WSR 09-07-092 filed on March 17, 2009, and published April 1, 2009.

Number of Sections Adopted in Order to Comply with Federal Statute: New 0, Amended 0, Repealed 0; Federal Rules or Standards: New 0, Amended 0, Repealed 0; or Recently Enacted State Statutes: New 0, Amended 0, Repealed 0.

Number of Sections Adopted at Request of a Nongovernmental Entity: New 0, Amended 0, Repealed 0.

Number of Sections Adopted on the Agency's Own Initiative: New 0, Amended 1, Repealed 0.

Number of Sections Adopted in Order to Clarify, Streamline, or Reform Agency Procedures: New 0, Amended 1, Repealed 0.

Number of Sections Adopted Using Negotiated Rule Making: New 0, Amended 0, Repealed 0; Pilot Rule Making: New 0, Amended 0, Repealed 0; or Other Alternative Rule Making: New 0, Amended 1, Repealed 0.

Date Adopted: May 18, 2009.

Susan Arland

Rules Coordinator

OTS-2141.2


AMENDATORY SECTION(Amending Order 457, filed 3/22/06, effective 1/1/08)

WAC 230-03-185   Applying for a manufacturer license.   (1) You must apply for a manufacturer license if you:

(((1))) (a) Make or assemble a completed piece or pieces of gambling equipment for use in authorized gambling activities; or

(((2))) (b) Convert, modify, combine, add to, or remove parts or components of any gambling equipment for use in authorized gambling activities.

(2) You must demonstrate your ability to comply with all manufacturing, quality control, and operations restrictions imposed on authorized gambling equipment that you want to manufacture or market for use in Washington state.

(3) The licensing process may include an on-site review of your manufacturing equipment and process for each separate type of authorized gambling equipment to ensure compliance capability.

[Statutory Authority: RCW 9.46.070. 06-07-157 (Order 457), 230-03-185, filed 3/22/06, effective 1/1/08.]

Washington State Code Reviser's Office