CERTIFICATION OF ENROLLMENT

ENGROSSED SUBSTITUTE HOUSE BILL 2496

Chapter 32, Laws of 2010

61st Legislature
2010 Regular Session



BALLOT DESIGN AND LAYOUT



EFFECTIVE DATE: 06/10/10

Passed by the House February 15, 2010
  Yeas 98   Nays 0

FRANK CHOPP
________________________________________    
Speaker of the House of Representatives


Passed by the Senate March 4, 2010
  Yeas 48   Nays 0


BRAD OWEN
________________________________________    
President of the Senate
 
CERTIFICATE

I, Barbara Baker, Chief Clerk of the House of Representatives of the State of Washington, do hereby certify that the attached is ENGROSSED SUBSTITUTE HOUSE BILL 2496 as passed by the House of Representatives and the Senate on the dates hereon set forth.


BARBARA BAKER
________________________________________    
Chief Clerk
Approved March 12, 2010, 2:05 p.m.








CHRISTINE GREGOIRE
________________________________________    
Governor of the State of Washington
 
FILED
March 12, 2010







Secretary of State
State of Washington


_____________________________________________ 

ENGROSSED SUBSTITUTE HOUSE BILL 2496
_____________________________________________

Passed Legislature - 2010 Regular Session
State of Washington61st Legislature2010 Regular Session

By House State Government & Tribal Affairs (originally sponsored by Representatives White, Orwall, Chase, Dickerson, Carlyle, Upthegrove, Springer, Nelson, Simpson, Miloscia, Dunshee, and Hunt)

READ FIRST TIME 01/20/10.   



     AN ACT Relating to ballot design; and amending RCW 29A.36.161.

BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF WASHINGTON:

Sec. 1   RCW 29A.36.161 and 2004 c 271 s 132 are each amended to read as follows:
     (1) On the top of each ballot must be printed clear and concise instructions directing the voter how to mark the ballot, including write-in votes. On the top of each primary ballot must be printed the instructions required by this chapter.
     (2) The ballot must have a clear delineation between the ballot instructions and the first ballot measure or office through the use of white space, illustration, shading, color, symbol, font size, or bold type. The secretary of state shall establish standards for ballot design and layout consistent with this act and RCW 29A.04.611.
     (3)
The questions of adopting constitutional amendments or any other state measure authorized by law to be submitted to the voters at that election must appear after the instructions and before any offices.
     (((3))) (4) In a year that president and vice president appear on the general election ballot, the names of candidates for president and vice president for each political party must be grouped together with a single response position for a voter to indicate his or her choice.
     (((4))) (5) On a general election ballot, the candidate or candidates of the major political party that received the highest number of votes from the electors of this state for the office of president of the United States at the last presidential election must appear first following the appropriate office heading. The candidate or candidates of the other major political parties will follow according to the votes cast for their nominees for president at the last presidential election, and independent candidates and the candidate or candidates of all other parties will follow in the order of their qualification with the secretary of state.
     (((5))) (6) All paper ballots and ballot cards used at a polling place must be sequentially numbered in such a way to permit removal of such numbers without leaving any identifying marks on the ballot.


         Passed by the House February 15, 2010.
         Passed by the Senate March 4, 2010.
         Approved by the Governor March 12, 2010.
         Filed in Office of Secretary of State March 12, 2010.