AN ACT Relating to ensuring that restrictions on the use of solid fuel burning devices do not prohibit the installation or replacement of solid fuel burning devices or the use of these devices during temporary outages of other sources of heat; and amending RCW 70.94.473.

BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF WASHINGTON:

Sec. 1.  RCW 70.94.473 and 2012 c 219 s 1 are each amended to read as follows:

(1) Any person in a residence or commercial establishment which has an adequate source of heat without burning wood shall:

(a) Not burn wood in any solid fuel burning device whenever the department has determined under RCW 70.94.715 that any air pollution episode exists in that area;

(b) Not burn wood in any solid fuel burning device except those which are either Oregon department of environmental quality phase II or United States environmental protection agency certified or certified by the department under RCW 70.94.457(1) or a pellet stove either certified or issued an exemption by the United States environmental protection agency in accordance with Title 40, Part 60 of the code of federal regulations, in the geographical area and for the period of time that a first stage of impaired air quality has been determined, by the department or any authority, for that area.

(i) A first stage of impaired air quality is reached when forecasted meteorological conditions are predicted to cause fine particulate levels to exceed thirty-five micrograms per cubic meter, measured on a twenty-four hour average, within forty-eight hours, except for areas of fine particulate nonattainment or areas at risk for fine particulate nonattainment;

(ii) A first stage burn ban for impaired air quality may be called for a county containing fine particulate nonattainment areas or areas at risk for fine particulate nonattainment, and when feasible only for the necessary portions of the county, when forecasted meteorological conditions are predicted to cause fine particulate levels to reach or exceed thirty micrograms per cubic meter, measured on a twenty-four hour average, within seventy-two hours; and

(c)(i) Not burn wood in any solid fuel burning device in a geographical area and for the period of time that a second stage of impaired air quality has been determined by the department or any authority, for that area. A second stage of impaired air quality is reached when a first stage of impaired air quality has been in force and has not been sufficient to reduce the increasing fine particulate pollution trend, fine particulates are at an ambient level of twenty-five micrograms per cubic meter measured on a twenty-four hour average, and forecasted meteorological conditions are not expected to allow levels of fine particulates to decline below twenty-five micrograms per cubic meter for a period of twenty-four hours or more from the time that the fine particulates are measured at the trigger level.

(ii) A second stage burn ban may be called without calling a first stage burn ban only when all of the following occur and shall require the department or the local air pollution control authority calling a second stage burn ban under this subsection to comply with the requirements of subsection (3) of this section:

(A) Fine particulate levels have reached or exceeded twenty-five micrograms per cubic meter, measured on a twenty-four hour average;

(B) Meteorological conditions have caused fine particulate levels to rise rapidly;

(C) Meteorological conditions are predicted to cause fine particulate levels to exceed the thirty-five micrograms per cubic meter, measured on a twenty-four hour average, within twenty-four hours; and

(D) Meteorological conditions are highly likely to prevent sufficient dispersion of fine particulate.

(iii) In fine particulate nonattainment areas or areas at risk for fine particulate nonattainment, a second stage burn ban may be called for the county containing the nonattainment area or areas at risk for nonattainment, and when feasible only for the necessary portions of the county, without calling a first stage burn ban only when (c)(ii)(A), (B), and (D) of this subsection have been met and meteorological conditions are predicted to cause fine particulate levels to reach or exceed thirty micrograms per cubic meter, measured on a twenty-four hour average, within twenty-four hours.

(2) Actions of the department and local air pollution control authorities under this section shall preempt actions of other state agencies and local governments for the purposes of controlling air pollution from solid fuel burning devices, except where authorized by chapter 199, Laws of 1991.

(3)(a) The department or any local air pollution control authority that has called a second stage burn ban under the authority of subsection (1)(c)(ii) of this section shall, within ninety days, prepare a written report describing:

(((a))) (i) The meteorological conditions that resulted in their calling the second stage burn ban;

(((b))) (ii) Whether the agency could have taken actions to avoid calling a second stage burn ban without calling a first stage burn ban; and

(((c))) (iii) Any changes the department or authority is making to its procedures of calling first stage and second stage burn bans to avoid calling a second stage burn ban without first calling a first stage burn ban.

(b) After consulting with affected parties, the department shall prescribe the format of such a report and may also require additional information be included in the report. All reports shall be sent to the department and the department shall keep the reports on file for not less than five years and available for public inspection and copying in accordance with RCW 42.56.090.

(4) For the purposes of chapter 219, Laws of 2012, an area at risk for nonattainment means an area where the three-year average of the annual ninety-eighth percentile of twenty-four hour fine particulate values is greater than twenty-nine micrograms per cubic meter, based on the years 2008 through 2010 monitoring data.

--- END ---