Summary

If your specific machine or operation is not listed here, then be sure to follow any of the following requirements that apply:

(1) General requirements for all saws and cutting heads in this section.

(2) General requirements for all saws in this section.

(3) General requirements for all cutting heads in this section.

(4) "Requirements for all machines" found in this chapter, WAC 296-806-200 and 296-806-300.

Reference:

For requirements on hand-held tools, see Portable power tools, chapter 296-807 WAC.

This section applies to fixed machines using saws or cutting heads that are used on any material.

Your responsibility:

To make sure machines using saws and cutting heads meet these requirements.

Requirements for this topic…	begin with this section:
GENERAL REQUIREMENTS FOR ALL SAWS AND CUTTING HEADS	WAC 296-806-48002

SAWS
General Requirements for All Saws	WAC 296-806-48006
Requirements for All Circular Saws	WAC 296-806-48008
Requirements for Specific Circular Saws	WAC 296-806-48024
Requirements for Band Saws and Drag Saws	WAC 296-806-48042

CUTTING HEADS
General Requirements for All Cutting Heads	WAC 296-806-48046

BORING AND MORTISING MACHINES	WAC 296-806-48048

CHIPPER AND HOG MILLS	WAC 296-806-48050

JOINTERS	WAC 296-806-48056

MOLDING, STICKING AND MATCHING MACHINES	WAC 296-806-48062

PANEL RAISERS AND OTHER SIMILAR MACHINES	WAC 296-806-48064

PLANERS	WAC 296-806-48066

SHAPERS	WAC 296-806-48074

TENONING MACHINES	WAC 296-806-48076

VENEER MACHINERY	WAC 296-806-48080

SEWING MACHINES	WAC 296-806-48502