(1) New sources.
A notice of construction application for a new or modified toxic air pollutant source must quantify the increase in the emissions of each TAP, after application of tBACT, emitted by the new or modified emission units.
(2) Small quantity emission rates.
A notice of construction application that relies on SQERs rather than dispersion modeling to demonstrate compliance with WAC
173-460-070 must quantify the increase in emissions of each TAP emitted by the new or modified emission units after application of tBACT. The quantification must contain sufficient detail to demonstrate to the satisfaction of the permitting authority that the increase in emissions is less than the applicable small quantity emission rates listed in WAC
173-460-150.
(3) Level of detail.
An acceptable source impact level analysis under WAC
173-460-080 may be based on a conservative estimate of emissions that represents good engineering judgment. If compliance with WAC
173-460-070 and
173-460-080 cannot be demonstrated, more precise emission estimates may be used to demonstrate compliance with WAC
173-460-090.
[Statutory Authority: Washington Clean Air Act, RCW
70.94.152. WSR 09-11-131 (Order 05-19), § 173-460-050, filed 5/20/09, effective 6/20/09. Statutory Authority: Chapter
70.94 RCW. WSR 94-03-072 (Order 93-19), § 173-460-050, filed 1/14/94, effective 2/14/94. Statutory Authority: RCW
70.94.331. WSR 91-13-079 (Order 90-62), § 173-460-050, filed 6/18/91, effective 9/18/91.]