(a) Manufacturer information:

(i) Manufacturer's name;

 

(ii) Mailing address;

 

(iii) Street address;

 

(iv) Phone number; and

 

(v) Email address.

(b) Manufacturer's authorized contact information:

(i) Name of the manufacturer's authorized contact;

 

(ii) Mailing address;

 

(iii) Street address;

 

(iv) Phone number; and

 

(v) Email address.

(c) If there is an agent, manufacturer's agent information:

(i) Name of the manufacturer's agent;

 

(ii) Mailing address;

 

(iii) Street address;

 

(iv) Phone number;

 

(v) Email address; and

 

(vi) A signed and dated statement from the agent verifying agent status. The statement must include the following: "I certify that I represent (insert manufacturing company name) and I am authorized to prepare or direct the preparation of this application for registration. I attest, under penalty of law, that this document and all attachments are true, accurate, and complete."

(d) Water-tightness certification:

A signed and dated statement from the manufacturer or agent certifying their sewage tank is watertight at the point of manufacturing. The certification must include:

 

(i) A description of the test method and identification of the person performing the test; or

 

(ii) The facility certification from National Precast Concrete Association testing.

(e) A full set of design drawings with supporting calculations:

(i) Design drawings stamped by the design engineer.

 

(ii) The design drawings meeting all the requirements in WAC 246-272C-0200.

(f) Installation instructions.

 

(g) A description of the function of the sewage tank along with any known limitation on its use.

 

(h) A design engineer's certification:

A signed and dated statement from the design engineer submitted with the design documents certifying the tank meets all standards and requirements in WAC 246-272C-0200 through 246-272C-0250.

(i) Proprietary product manufacturer statement, if the tank is used with a proprietary product listed with the department:

A signed and dated statement from the proprietary product manufacturer:

(i) Identifying the proprietary product model number; and

 

(ii) Stating the tank drawings were reviewed and found acceptable for use with the specified proprietary product.

(j) Payment of all applicable fees.