You must meet the requirements … | in this section: |
Make sure suspended scaffolds and scaffold components meet these strength requirements | WAC 296-874-30002 |
Make sure suspended scaffold outrigger beams meet these requirements | WAC 296-874-30004 |
Make sure counterweights are safe and used properly | WAC 296-874-30006 |
Make sure tiebacks meet these requirements | WAC 296-874-30008 |
Make sure suspended scaffold support devices meet these requirements | WAC 296-874-30010 |
Make sure scaffold hoists meet these requirements | WAC 296-874-30012 |
Make sure scaffold hoists retain enough suspension rope | WAC 296-874-30014 |
Make sure wire rope is in good condition | WAC 296-874-30016 |
Make sure wire suspension rope connections meet these requirements | WAC 296-874-30018 |
Make sure wire rope clips are used properly | WAC 296-874-30020 |
Prevent swaying of two-point and multipoint suspension scaffolds | WAC 296-874-30022 |
Use emergency escape and rescue devices appropriately | WAC 296-874-30024 |
Protect suspension ropes from heat or corrosive substances | WAC 296-874-30026 |
Take precautions while welding | WAC 296-874-30028 |
Prohibit use of gasoline-powered equipment on suspended scaffolds | WAC 296-874-30030 |
Meet these requirements when using catenary scaffolds | WAC 296-874-30032 |
Meet these requirements when using float (ship) scaffolds | WAC 296-874-30034 |
Meet these requirements when using interior hung scaffolds | WAC 296-874-30036 |
Meet these requirements when using multilevel suspended scaffolds | WAC 296-874-30038 |
Meet these requirements when using multipoint adjustable suspension scaffolds | WAC 296-874-30040 |
Meet these requirements when using needle beam scaffolds | WAC 296-874-30042 |
Meet these requirements when using single-point adjustable suspension scaffolds | WAC 296-874-30044 |
Meet these requirements when using two-point adjustable suspension scaffolds (swing stages) | WAC 296-874-30046 |