Effective Date of Rule: Thirty-one days after filing.

     Purpose: Amend the registration program to clarify when and how rock crushing operations must register with this agency.

     Citation of Existing Rules Affected by this Order: Amending Regulation I, Section 5.03 (Applicability of Registration Program); and adopt Section 5.12 (Registration of Crushing Operations).

     Statutory Authority for Adoption: Chapter 70.94 RCW.

      Adopted under notice filed as WSR 11-22-106 on November 2, 2011.

     Changes Other than Editing from Proposed to Adopted Version: None. Added clarification for moving registration to another site at Regulation I, Section 5.12 (b)(3).

     Number of Sections Adopted in Order to Comply with Federal Statute: New 0, Amended 0, Repealed 0; Federal Rules or Standards: New 0, Amended 0, Repealed 0; or Recently Enacted State Statutes: New 0, Amended 0, Repealed 0.

     Number of Sections Adopted at Request of a Nongovernmental Entity: New 0, Amended 0, Repealed 0.

     Number of Sections Adopted on the Agency's Own Initiative: New 0, Amended 0, Repealed 0.

     Number of Sections Adopted in Order to Clarify, Streamline, or Reform Agency Procedures: New 0, Amended 0, Repealed 0.

     Number of Sections Adopted Using Negotiated Rule Making: New 0, Amended 0, Repealed 0;      Pilot Rule Making: New 0, Amended 0, Repealed 0; or Other Alternative Rule Making: New 0, Amended 0, Repealed 0.

     Date Adopted: January 26, 2012.

Craig Kenworthy

Executive Director

REGULATION I, SECTION 5.03 APPLICABILITY OF REGISTRATION PROGRAM

     (a) The requirements of this article shall apply only to:

     (1) Sources subject to a federal emission standard under:

     (A) 40 CFR Part 60 (except Subparts B, S, BB, and AAA, and the provisions of Subpart IIII pertaining to owners and operators of emergency stationary compression ignition internal combustion engines);

     (B) 40 CFR Part 61 (except Subparts B, H, I, K, Q, R, T, W, and the provisions of Subpart M pertaining to asbestos on roadways, asbestos demolition and renovation activities, and asbestos spraying);

     (C) 40 CFR Part 62; or

     (D) 40 CFR Part 63 (except Subpart LL, the provisions of Subparts S and MM pertaining to kraft and sulfite pulp mills, the provisions of Subpart ZZZZ pertaining to emergency and limited-use stationary reciprocating internal combustion engines, and Subparts WWWWW, CCCCCC, HHHHHH, WWWWWW, XXXXXX, YYYYYY, and ZZZZZZ);

     (2) Sources with a federally enforceable emission limitation established in order to avoid operating permit program applicability under Article 7 of this regulation;

     (3) Sources with annual emissions:

     (A) Greater than or equal to 2.50 tons of any single hazardous air pollutant (HAP);

     (B) Greater than or equal to 6.25 tons of total hazardous air pollutants (HAP); or

     (C) Greater than or equal to 25.0 tons of carbon monoxide      (CO), nitrogen oxides (NOx), particulate matter (PM2.5 or PM10), sulfur oxides (SOx), or volatile organic compounds (VOC);

     (4) Sources subject to the following sections of Regulation I, II, or III:

     (A) Refuse burning equipment subject to Section 9.05 of Regulation I (including crematories);

     (B) Fuel burning equipment or refuse burning equipment burning oil that exceeds any limit in Section 9.08 of Regulation I and sources marketing oil to such sources;

     (C) Fuel burning equipment subject to Section 9.09 of Regulation I with a rated heat input greater than or equal to 1 MMBtu/hr of any fuel other than natural gas, propane, butane, or distillate oil, or greater than or equal to 10 MMBtu/hr of any fuel;

     (D) Sources with spray-coating operations subject to Section 9.16 of Regulation I;

     (E) Petroleum refineries subject to Section 2.03 of Regulation II;

     (F) Gasoline loading terminals subject to Section 2.05 of Regulation II;

     (G) Gasoline dispensing facilities subject to Section 2.07 of Regulation II;

     (H) Volatile organic compound storage tanks subject to Section 3.02 of Regulation II;

     (I) Can and paper coating facilities subject to Section 3.03 of Regulation II;

     (J) Motor vehicle and mobile equipment coating operations subject to Section 3.04 of Regulation II;

     (K) Flexographic and rotogravure printing facilities subject to Section 3.05 of Regulation II;

     (L) Polyester, vinylester, gelcoat, and resin operations subject to Section 3.08 of Regulation II;

     (M) Aerospace component coating operations subject to Section 3.09 of Regulation II;

     (N) Crushing operations subject to Section 9.18 (((Reserved))); or

     (O) Ethylene oxide sterilizers subject to Section 3.07 of Regulation III;

     (5) Sources with any of the following gas or odor control equipment having a rated capacity of greater than or equal to 200 cfm (>4" diameter inlet):

     (A) Activated carbon adsorption;

     (B) Afterburner;

     (C) Barometric condenser;

     (D) Biofilter;

     (E) Catalytic afterburner;

     (F) Catalytic oxidizer;

     (G) Chemical oxidation;

     (H) Condenser;

     (I) Dry sorbent injection;

     (J) Flaring;

     (K) Non-selective catalytic reduction;

     (L) Refrigerated condenser;

     (M) Selective catalytic reduction; or

     (N) Wet scrubber;

     (6) Sources with any of the following particulate control equipment having a rated capacity of greater than or equal to 2,000 cfm (>10" diameter inlet):

     (A) Baghouse;

     (B) Demister;

     (C) Electrostatic precipitator;

     (D) HEPA (high efficiency particulate air) filter;

     (E) HVAF (high velocity air filter);

     (F) Mat or panel filter;

     (G) Mist eliminator;

     (H) Multiple cyclones;

     (I) Rotoclone;

     (J) Screen;

     (K) Venturi scrubber;

     (L) Water curtain; or

     (M) Wet electrostatic precipitator;

     (7) Sources with a single cyclone having a rated capacity of greater than or equal to 20,000 cfm (>27" diameter inlet);

     (8) Sources with any of the following equipment:

     (A) Asphalt batch plants;

     (B) Burn-off ovens;

     (C) Coffee roasters;

     (D) Commercial composting with raw materials from off-site;

     (E) Commercial smokehouses with odor control equipment;

     (F) Concrete batch plants (ready-mix concrete);

     (G) Galvanizing;

     (H) Iron or steel foundries;

     (I) Microchip or printed circuit board manufacturing;

     (J) Rendering plants;

     (K) Rock crushers or concrete crushers;

     (L) Sewage treatment plants with odor control equipment;

     (M) Shipyards;

     (N) Steel mills;

     (O) Wood preserving lines or retorts; or

     (P) Dry cleaners using perchloroethylene; and

     (9) Sources with equipment (or control equipment) that has been determined by the Control Officer to warrant registration through review of a Notice of Construction application under Section 6.03(a) or a Notification under Section 6.03(b) of this regulation, due to the amount and nature of air contaminants produced, or the potential to contribute to air pollution, and with special reference to effects on health, economic and social factors, and physical effects on property.

     (b) The requirements of this article shall not apply to:

     (1) Motor vehicles;

     (2) Nonroad engines or nonroad vehicles as defined in Section 216 of the federal Clean Air Act;

     (3) Sources that require an operating permit under Article 7 of this regulation;

     (4) Solid fuel burning devices subject to Article 13 of this regulation; or

     (5) Any source, including any listed in Sections 5.03 (a)(4) through 5.03 (a)(9) of this regulation, that has been determined through review by the Control Officer not to warrant registration, due to the amount and nature of air contaminants produced or the potential to contribute to air pollution, and with special reference to effects on health, economic and social factors, and physical effects on property.

     (c) It shall be unlawful for any person to cause or allow the operation of any source subject to registration under this section, unless it meets all the requirements of Article 5 of this regulation.

     (d) An exemption from new source review under Article 6 of this regulation shall not be construed as an exemption from registration under this article. In addition, an exemption from registration under this article shall not be construed as an exemption from any other provision of Regulation I, II, or III.

NEW SECTION

REGULATION I, SECTION 5.12 REGISTRATION OF CRUSHING OPERATIONS

     (a) Applicability - This section applies to all crushing operations subject to registration under Section 5.03 of this regulation. Every site which has crushing equipment installed for operation shall be registered with this Agency prior to any crushing operation.

     (b) Initial Registration

     (1) New crushing operations shall be registered with this agency prior to operation commencing through submittal of the crushing operation information specified on registration forms provided by the agency. All information on the registration form shall be provided as specified. Incomplete registration form submittals will not be acceptable to create an active registration.

     (2) Registration is not completed until all fees due are paid, as identified in Section 5.12 (c)(3) of this regulation.

     (3) The valid registration of an existing crushing operation may be moved to another site without a new registration, provided that no other operable crushing equipment installed for active operation on a site is using that same registration.

     (c) Fees

     (1) Registration fees for crushing operations shall be assessed as identified in Section 5.07 of this regulation.

     (A) Registered crushing operations may maintain registration through payment of the annual invoices sent to actively registered sources.

     (B) Initial registration of a crushing operation shall be subject to the fees identified in Section 5.07 of this regulation. There is no proration of fees for registration of crushing operations that are less than a full year. Registration fees in Section 5.07 (and as identified on the forms provided by the Agency) shall be submitted with the initial registration. Inapplicable federal emission standard fees identified in Section 5.07 (c)(1) of this regulation will be refunded, as determined through review of the registration submittal.

     (2) Unregistered crushing operations at a site are subject to the penalty provisions identified in Section 5.07(b).

     (d) Operational Information - The owner or operation of a crushing operation shall maintain records of sites and dates crushing occurred in this Agency's jurisdiction. All records must be current, retained for at least 2 years, and available to Agency representatives upon request.

© Washington State Code Reviser's Office