BILL REQ. #:  H-4508.1 

Read first time 01/28/2004.   Referred to Committee on Commerce & Labor.

     AN ACT Relating to evaluating armed service experience in specialized electrical fields; and reenacting and amending RCW 19.28.191.

BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF WASHINGTON:

Sec. 1   RCW 19.28.191 and 2003 c 399 s 601 and 2003 c 211 s 1 are each reenacted and amended to read as follows:
     (1) Upon receipt of the application, the department shall review the application and determine whether the applicant is eligible to take an examination for the master journeyman electrician, journeyman electrician, master specialty electrician, or specialty electrician certificate of competency.
     (a) Before July 1, 2005, an applicant who possesses a valid journeyman electrician certificate of competency in effect for the previous four years and a valid general administrator's certificate may apply for a master journeyman electrician certificate of competency without examination.
     (b) Before July 1, 2005, an applicant who possesses a valid specialty electrician certificate of competency, in the specialty applied for, for the previous two years and a valid specialty administrator's certificate, in the specialty applied for, may apply for a master specialty electrician certificate of competency without examination.
     (c) Before December 1, 2003, the following persons may obtain an equipment repair specialty electrician certificate of competency without examination:
     (i) A person who has successfully completed an apprenticeship program approved under chapter 49.04 RCW for the machinist trade; and
     (ii) A person who provides evidence in a form prescribed by the department affirming that: (A) He or she was employed as of April 1, 2003, by a factory-authorized equipment dealer or service company; and (B) he or she has worked in equipment repair for a minimum of four thousand hours.
     (d) To be eligible to take the examination for a master journeyman electrician certificate of competency the applicant must have possessed a valid journeyman electrician certificate of competency for four years.
     (e) To be eligible to take the examination for a master specialty electrician certificate of competency the applicant must have possessed a valid specialty electrician certificate of competency, in the specialty applied for, for two years.
     (f) To be eligible to take the examination for a journeyman certificate of competency the applicant must have:
     (i) Worked in the electrical construction trade for a minimum of eight thousand hours, of which four thousand hours shall be in industrial or commercial electrical installation under the supervision of a master journeyman electrician or journeyman electrician and not more than a total of four thousand hours in all specialties under the supervision of a master journeyman electrician, journeyman electrician, master specialty electrician working in that electrician's specialty, or specialty electrician working in that electrician's specialty. Speciality electricians with less than a four thousand hour work experience requirement cannot credit the time required to obtain that specialty towards qualifying to become a journeyman electrician; or
     (ii) Successfully completed an apprenticeship program approved under chapter 49.04 RCW for the electrical construction trade.
     (g) To be eligible to take the examination for a specialty electrician certificate of competency the applicant must have:
     (i) Worked in the residential (as specified in WAC 296-46A-930(2)(a)), pump and irrigation (as specified in WAC 296-46A-930(2)(b)(i)), sign (as specified in WAC 296-46A-930(2)(c)), limited energy (as specified in WAC 296-46A-930(2)(e)(i)), nonresidential maintenance (as specified in WAC 296-46A-930(2)(f)(i)), or other new nonresidential specialties as determined by the department in rule under the supervision of a master journeyman electrician, journeyman electrician, master specialty electrician working in that electrician's specialty, or specialty electrician working in that electrician's specialty for a minimum of four thousand hours; or
     (ii) Worked in the appliance repair specialty as determined by the department in rule, restricted nonresidential maintenance as determined by the department in rule, the equipment repair specialty as determined by the department in rule, or a specialty other than the designated specialties in (g)(i) of this subsection for a minimum of the initial ninety days, or longer if set by rule by the department. The restricted nonresidential maintenance specialty is limited to a maximum of 277 volts and 20 amperes for lighting branch circuits and/or a maximum of 250 volts and 60 amperes for other circuits, but excludes the replacement or repair of circuit breakers. The initial period must be spent under one hundred percent supervision of a master journeyman electrician, journeyman electrician, master specialty electrician working in that electrician's specialty, or specialty electrician working in that electrician's specialty. After this initial period, a person may take the specialty examination. If the person passes the examination, the person may work unsupervised for the balance of the minimum hours required for certification. A person may not be certified as a specialty electrician in the appliance repair specialty or in a specialty other than the designated specialities in (g)(i) of this subsection, however, until the person has worked a minimum of two thousand hours in that specialty, or longer if set by rule by the department; or
     (iii) Successfully completed an approved apprenticeship program under chapter 49.04 RCW for the applicant's specialty in the electrical construction trade.
     (h) Any applicant for a journeyman electrician certificate of competency who has successfully completed a two-year program in the electrical construction trade at public community or technical colleges, or not-for-profit nationally accredited technical or trade schools licensed by the work force training and education coordinating board under chapter 28C.10 RCW may substitute up to two years of the technical or trade school program for two years of work experience under a master journeyman electrician or journeyman electrician. The applicant shall obtain the additional two years of work experience required in industrial or commercial electrical installation prior to the beginning, or after the completion, of the technical school program. Any applicant who has received training in the electrical construction trade in the armed service of the United States may be eligible to apply armed service work experience towards qualification to take the examination for the journeyman electrician certificate of competency.
     (i) An applicant for a specialty electrician certificate of competency who, after January 1, 2000, has successfully completed a two-year program in the electrical construction trade at a public community or technical college, or a not-for-profit nationally accredited technical or trade school licensed by the work force training and education coordinating board under chapter 28C.10 RCW, may substitute up to one year of the technical or trade school program for one year of work experience under a master journeyman electrician, journeyman electrician, master specialty electrician working in that electrician's specialty, or specialty electrician working in that electrician's specialty. Any applicant who has received training in the electrical construction trade in the armed services of the United States may be eligible to apply armed service work experience towards qualification to take the examination for an appropriate specialty electrician certificate of competency.
     (j) The department must determine whether hours of training and experience in the armed services or school program are in the electrical construction trade and appropriate as a substitute for hours of work experience.
     (i) The department must use the following criteria for evaluating the equivalence of armed service experience. The department may allow armed service experience as a substitute for work experience if the applicant has armed service experience in a specialized electrical field that is similar to a specialty recognized by the department in rule. Armed service experience allowed as a substitute for work experience should include, but is not limited to, building construction experience, and nuclear, marine, or other shipboard experience.
     (ii) The department must use the following criteria for evaluating the equivalence of classroom electrical training programs and work in the electrical construction trade:
     (((i))) (A) A two-year electrical training program must consist of three thousand or more hours.
     (((ii))) (B) In a two-year electrical training program, a minimum of two thousand four hundred hours of student/instructor contact time must be technical electrical instruction directly related to the scope of work of the electrical specialty. Student/instructor contact time includes lecture and in-school lab.
     (((iii))) (C) The department may not allow credit for a program that accepts more than one thousand hours transferred from another school's program.
     (((iv))) (D) Electrical specialty training school programs of less than two years will have all of the above student/instructor contact time hours proportionately reduced. Such programs may not apply to more than fifty percent of the work experience required to attain certification.
     (((v))) (E) Electrical training programs of less than two years may not be credited towards qualification for journeyman electrician unless the training program is used to gain qualification for a four thousand hour electrical specialty.
     (k) No other requirement for eligibility may be imposed.
     (2) The department shall establish reasonable rules for the examinations to be given applicants for certificates of competency. In establishing the rules, the department shall consult with the board. Upon determination that the applicant is eligible to take the examination, the department shall so notify the applicant, indicating the time and place for taking the examination.
     (3) No noncertified individual may work unsupervised more than one year beyond the date when the trainee would be eligible to test for a certificate of competency if working on a full-time basis after original application for the trainee certificate. For the purposes of this section, full-time basis means two thousand hours.