(a) Except for proposed locations used solely for the pilot program purposes permitted under subsection (6) of this section, the appropriate local legislative authority must prepare an analysis of the locations within the jurisdiction where automated traffic safety cameras are proposed to be located: (i) Before enacting an ordinance allowing for the initial use of automated traffic safety cameras; and (ii) before adding additional cameras or relocating any existing camera to a new location within the jurisdiction. Automated traffic safety cameras may be used to detect one or more of the following: Stoplight, railroad crossing, or school speed zone violations; ((or)) speed violations subject to (c) of this subsection; or violations included in subsection (6) of this section for the duration of the pilot program authorized under subsection (6) of this section. At a minimum, the local ordinance must contain the restrictions described in this section and provisions for public notice and signage. Cities and counties using automated traffic safety cameras before July 24, 2005, are subject to the restrictions described in this section, but are not required to enact an authorizing ordinance. Beginning one year after June 7, 2012, cities and counties using automated traffic safety cameras must post an annual report of the number of traffic accidents that occurred at each location where an automated traffic safety camera is located as well as the number of notices of infraction issued for each camera and any other relevant information about the automated traffic safety cameras that the city or county deems appropriate on the city's or county's web site.

(b) Except as provided in (c) of this subsection and subsection (6) of this section, use of automated traffic safety cameras is restricted to the following locations only: (i) Intersections of two or more arterials with traffic control signals that have yellow change interval durations in accordance with RCW 47.36.022, which interval durations may not be reduced after placement of the camera; (ii) railroad crossings; and (iii) school speed zones.

(d) Automated traffic safety cameras may only take pictures of the vehicle and vehicle license plate and only while an infraction is occurring. The picture must not reveal the face of the driver or of passengers in the vehicle. The primary purpose of camera placement is to take pictures of the vehicle and vehicle license plate when an infraction is occurring. Cities and counties shall consider installing cameras in a manner that minimizes the impact of camera flash on drivers.

(e) A notice of infraction must be mailed to the registered owner of the vehicle within fourteen days of the violation, or to the renter of a vehicle within fourteen days of establishing the renter's name and address under subsection (3)(a) of this section. The law enforcement officer issuing the notice of infraction shall include with it a certificate or facsimile thereof, based upon inspection of photographs, microphotographs, or electronic images produced by an automated traffic safety camera, stating the facts supporting the notice of infraction. This certificate or facsimile is prima facie evidence of the facts contained in it and is admissible in a proceeding charging a violation under this chapter. The photographs, microphotographs, or electronic images evidencing the violation must be available for inspection and admission into evidence in a proceeding to adjudicate the liability for the infraction. A person receiving a notice of infraction based on evidence detected by an automated traffic safety camera may respond to the notice by mail.

(f) The registered owner of a vehicle is responsible for an infraction under RCW 46.63.030(1)(d) unless the registered owner overcomes the presumption in RCW 46.63.075, or, in the case of a rental car business, satisfies the conditions under subsection (3) of this section. If appropriate under the circumstances, a renter identified under subsection (3)(a) of this section is responsible for an infraction.

(g) Notwithstanding any other provision of law, all photographs, microphotographs, or electronic images prepared under this section are for the exclusive use of law enforcement in the discharge of duties under this section and are not open to the public and may not be used in a court in a pending action or proceeding unless the action or proceeding relates to a violation under this section. No photograph, microphotograph, or electronic image may be used for any purpose other than enforcement of violations under this section nor retained longer than necessary to enforce this section.

(h) All locations where an automated traffic safety camera is used must be clearly marked at least thirty days prior to activation of the camera by placing signs in locations that clearly indicate to a driver that he or she is entering a zone where traffic laws are enforced by an automated traffic safety camera. Signs placed in automated traffic safety camera locations after June 7, 2012, must follow the specifications and guidelines under the manual of uniform traffic control devices for streets and highways as adopted by the department of transportation under chapter 47.36 RCW.

(i) If a county or city has established an authorized automated traffic safety camera program under this section, the compensation paid to the manufacturer or vendor of the equipment used must be based only upon the value of the equipment and services provided or rendered in support of the system, and may not be based upon a portion of the fine or civil penalty imposed or the revenue generated by the equipment.

(2) Infractions detected through the use of automated traffic safety cameras are not part of the registered owner's driving record under RCW 46.52.101 and 46.52.120. Additionally, infractions generated by the use of automated traffic safety cameras under this section shall be processed in the same manner as parking infractions, including for the purposes of RCW 3.50.100, 35.20.220, 46.16A.120, and 46.20.270(2). The amount of the fine issued for an infraction generated through the use of an automated traffic safety camera shall not exceed the amount of a fine issued for other parking infractions within the jurisdiction. However, the amount of the fine issued for a traffic control signal violation detected through the use of an automated traffic safety camera shall not exceed the monetary penalty for a violation of RCW 46.61.050 as provided under RCW 46.63.110, including all applicable statutory assessments.

(3) If the registered owner of the vehicle is a rental car business, the law enforcement agency shall, before a notice of infraction being issued under this section, provide a written notice to the rental car business that a notice of infraction may be issued to the rental car business if the rental car business does not, within eighteen days of receiving the written notice, provide to the issuing agency by return mail:

(b) A statement under oath that the business is unable to determine who was driving or renting the vehicle at the time the infraction occurred because the vehicle was stolen at the time of the infraction. A statement provided under this subsection must be accompanied by a copy of a filed police report regarding the vehicle theft; or

(5)(a) For the purposes of this section, "automated traffic safety camera" means a device that uses a vehicle sensor installed to work in conjunction with an intersection traffic control system, a railroad grade crossing control system, or a speed measuring device, and a camera synchronized to automatically record one or more sequenced photographs, microphotographs, or electronic images of the rear of a motor vehicle at the time the vehicle fails to stop when facing a steady red traffic control signal or an activated railroad grade crossing control signal, or exceeds a speed limit as detected by a speed measuring device.

(b) For the purposes of the pilot program authorized under subsection (6) of this section, "automated traffic safety camera" also includes a device used to detect stopping when traffic obstructed violations; stopping at intersection or crosswalk violations; public transportation only lane violations; stopping or traveling in restricted lane violations; and stopping or parking violations at locations restricted for emergency response vehicle entry or exit or the boarding or disembarking of public transportation vehicles, including public ferries.

(6) ((During the 2011-2013 and 2013-2015 fiscal biennia, this section does not apply to automated traffic safety cameras for the purposes of section 216(5), chapter 367, Laws of 2011 and section 216(6), chapter 306, Laws of 2013.))(a)(i) A city with a population greater than five hundred thousand may adopt an ordinance creating a pilot program authorizing automated traffic safety cameras to be used to detect one or more of the following violations: Stopping when traffic obstructed violations; stopping at intersection or crosswalk violations; public transportation only lane violations; stopping or traveling in restricted lane violations; and stopping or parking violations at locations restricted for emergency response vehicle entry or exit or the boarding or disembarking of public transportation vehicles, including public ferries. At a minimum, the local ordinance must contain the restrictions described in this section and provisions for public notice and signage.

(B) Regarding any violation detected under this pilot program with respect to trucks parked for the purposes of delivering commercial products between the hours of midnight to 5 a.m. in public transportation only lanes or in lanes restricted for high occupancy vehicles, a warning notice with no penalty must be issued to the registered owner of the vehicle.

(iii) As used in this subsection (6), "public transportation vehicle" means any motor vehicle, streetcar, train, trolley vehicle, ferry boat, or any other device, vessel, or vehicle that is owned or operated by a transit authority or an entity providing service on behalf of a transit authority that is used for the purpose of carrying passengers and that operates on established routes. "Transit authority" has the meaning provided in RCW 9.91.025.

(b) Use of automated traffic safety cameras as authorized in this subsection (6) is restricted to the following locations only: Locations authorized in subsection (1)(b) of this section; and midblock on arterials. Additionally, the use of automated traffic safety cameras as authorized in this subsection (6) is further limited to the following:

(c) From the effective date of this section until January 1, 2020, a warning notice with no penalty must be issued to the registered owner of the vehicle for a violation generated through the use of an automated traffic safety camera authorized in this subsection (6). Beginning January 1, 2020, a warning notice with no penalty must be issued to the registered owner of the vehicle for the first violation generated through the use of an automated traffic safety camera authorized in this subsection (6) after January 1, 2020, and a notice of infraction must be issued, but only for a second or subsequent violation, in a manner consistent with subsections (1)(e) and (3) of this section for an infraction generated through the use of an automated traffic safety camera authorized in this subsection (6).

(d) For violations issued as authorized in this subsection (6), a city with a pilot program shall remit monthly to the state fifty percent of the noninterest money received under this subsection (6) in excess of the cost to install, operate, and maintain the automated traffic safety cameras for use in the pilot program. Money remitted under this subsection to the state treasurer shall be deposited in the highway safety fund created in RCW 46.68.060.

(e) A city that implements a pilot program under this subsection (6) must provide a report to the transportation committees of the legislature by June 30, 2021, on the pilot program that includes the locations chosen for the automated traffic safety cameras used in the pilot program, the number of traffic infractions issued under the pilot program, the number of traffic infractions issued with respect to vehicles registered outside of the county in which the city is located, safety and on-time performance statistics related to the impact on driver behavior of the use of automated traffic safety cameras in the pilot program, and any recommendations on the use of automated traffic safety cameras to enforce the violations that these cameras were authorized to detect under the pilot program.

(a) The appropriate local legislative authority must prepare an analysis of the locations within the jurisdiction where automated traffic safety cameras are proposed to be located: (i) Before enacting an ordinance allowing for the initial use of automated traffic safety cameras; and (ii) before adding additional cameras or relocating any existing camera to a new location within the jurisdiction. Automated traffic safety cameras may be used to detect one or more of the following: Stoplight, railroad crossing, or school speed zone violations; or speed violations subject to (c) of this subsection. At a minimum, the local ordinance must contain the restrictions described in this section and provisions for public notice and signage. Cities and counties using automated traffic safety cameras before July 24, 2005, are subject to the restrictions described in this section, but are not required to enact an authorizing ordinance. Beginning one year after June 7, 2012, cities and counties using automated traffic safety cameras must post an annual report of the number of traffic accidents that occurred at each location where an automated traffic safety camera is located as well as the number of notices of infraction issued for each camera and any other relevant information about the automated traffic safety cameras that the city or county deems appropriate on the city's or county's web site.

(b) Except as provided in (c) of this subsection, use of automated traffic safety cameras is restricted to the following locations only: (i) Intersections of two or more arterials with traffic control signals that have yellow change interval durations in accordance with RCW 47.36.022, which interval durations may not be reduced after placement of the camera; (ii) railroad crossings; and (iii) school speed zones.

(5) For the purposes of this section, "automated traffic safety camera" means a device that uses a vehicle sensor installed to work in conjunction with an intersection traffic control system, a railroad grade crossing control system, or a speed measuring device, and a camera synchronized to automatically record one or more sequenced photographs, microphotographs, or electronic images of the rear of a motor vehicle at the time the vehicle fails to stop when facing a steady red traffic control signal or an activated railroad grade crossing control signal, or exceeds a speed limit as detected by a speed measuring device.